Views: 0 Author: Site Editor Publish Time: 2024-07-08 Origin: Site
1. If the tension of the triangular tape cannot meet the specified requirements after regular inspection and adjustment, it must be replaced with a new triangular tape. When replacing, all belts on the same pulley should be replaced at the same time. Otherwise, due to differences in length between new and old belts, the load distribution on the V-belt is uneven, causing vibration and unstable transmission, which reduces the efficiency of V-belt transmission.
2. During use, the operating temperature of the V-belt should not exceed 60 ℃, and do not apply belt grease casually. If the surface of the V-belt emits light, it indicates that the V-belt has slipped. First, remove the dirt on the surface of the belt, and then apply an appropriate amount of belt wax. When cleaning the V-belt, use warm water instead of cold and hot water.
3. For various models of V-belts, it is not advisable to apply rosin or viscous substances, and it is also necessary to prevent contamination of engine oil, butter, diesel, and gasoline, otherwise it will corrode the V-belt and shorten its service life. The groove of the V-belt should not be stained with oil, otherwise it will slip.
4. When the V-belt is not in use, it should be kept well and stored in a place with relatively low temperature, no direct sunlight exposure, and no oil or corrosive smoke to prevent it from deteriorating.
